Murphy PowerView PV-101 Manuel d'utilisateur télécharger pdf (Page 31)

00-02-0605 - 27 - Rev 09-10-08

Troubleshooting

“WAIT TO START PREHEATING” is displayed

The ECU is broadcasting a 'Wait To Start' message. Engine

manufacturers typically recommend against starting the

engine while the ECU is broadcasting this message. Once

the ECU stops broadcasting this message, this screen will

no longer be displayed on the PowerView.

“CANBUS FAILURE” is displayed

The PowerView has not received any valid J1939 CAN

messages for at least 30 seconds.

“TIMEOUT ECU NOT RESPONDING” is displayed

The PowerView sent a request to the ECU for Stored Fault

Code (DM2) information, and the ECU did not respond to

the request. This message on the PowerView indicates the

ECU may not support Stored Fault Code (DM2) functionality

over J1939.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36

Pas de commentaire

Murphy PowerView PV-101 Manuel d'utilisateur Page 31