Murphy EVS-2 Spécifications télécharger pdf (Page 15)

Section 20 00-02-2003

06-21-10 - 11 -

External Standard Accelerometer Wiring

1. Remove the EVS EX top cover.

2. Connect the Power and Relay wires per instructions above.

3. Place a slotted screw driver in the slot of the 3-pin connector. Pry the screw driver

away from the back of the connector until the connector comes loose from the header.

4. Lift the connector off the header.

5. Connect the external accelerometer wires as indicated in the pin out diagram below.

Standard External

Accelerometer Wiring

PHASE OUT / DISCONTINUED

Check Availability

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 23 24

Pas de commentaire

Murphy EVS-2 Spécifications Page 15